12 x 0 Fiber Trunk Module NTBB20FB

• The Norstar 12 x 0 Fiber Station Module allows the addition of up to twelve LS/DS trunks, Caller ID Trunks to your Norstar Modular ICS System. The Norstar 6 Port Fiber Combo/Expansion Card, 6 Port Fiber Expansion or the 2 Port Fiber Expansion Card is required to run the Norstar 12 x 0 Fiber Trunk Module. The 12 x 0 Fiber Trunk Module is compatible with all versions of the Norstar Modular ICS system.
• Trunk Module may be connected to core units for the addition of incoming lines
• Each trunk Module can hold up to three trunk cartridges
• Emergency transfer port

0 x 16 station Module NTBB41FB 93

• The Norstar 0 x 16 Fiber Station Module allows the addition of up to 16 telephones to your Norstar Modular ICS System.
• The 0 x 16 Station Module is compatible with all versions of the Norstar Modular ICS system.

Analog Station Module NTBB51CA 93

• The Norstar Analogue Station Module connects to your Norstar Modular ICS system
• Compatible with Modular ICS products with fiber interface capabilities
• Supports eight data or voice analog devices these ports can be used for either telephones, fax machines or modems
• Standard module is compatible with all Modular ICS software release

BCM Expansion Modules

• These expansion modules are compatible with the Nortel BCM 200 and BCM 400

LS/DS Trunk Cartridge NT7B75GA / NT7B69

• The Norstar LS/DS card has four analog CO Trunks or Lines. The Norstar LS/DS Card is compatible with the Norstar Modular ICS & Compact ICS. Can add up to 3 LS/DS Cards to a Norstar 12 x 0 Station Module
• Provides access for up to four central office lines
• Disconnect Supervision capabilities
• Compatible with the modular ICS, Fiber, and Copper Trunk Modules, Compact ICS and the Modular 8 x 24

Caller ID Trunk Cartridge NT7B75AAAE / NT7B75AAAF

• The Norstar Caller ID Card has four Caller ID Trunks or Lines.
• Caller ID CID Trunk Cartridge has the same functionality as the LS/DS Trunk Cartridge but with additional capabilities to detect and translate incoming call information for display on the Norstar sets
• Provides access for up to four central office lines
• Compatible with the modular ICS, Fiber, and Copper Trunk Modules, Compact ICS and the Modular 8 x 24

• The Digital Trunk Interface (DTI) cartridge provides access for up to twenty-four digital T1 or ISDN-PRI channels. It comes equipped with built-in Channel Service Unit (CSU) functionality to support the integrity of digital signaling.
• The core Modular ICS can support up to two DTI's for a total of forty-eight T1 or ISDN-PRI (digital) lines. DTI's cannot be installed in Trunk Modules.
• Requires either the Services Cartridge or the Combination Fiber 6-Port Services Cartridge.
• Compatible with the Modular ICS core only. ISDN-PRI Enabler Soft Key
• The ISDN-PRI Enabler Soft Key is required to configure the Digital Trunk Cartridge (DTI Card) as a PRI card.

Nortel Cards - Service Cartridge NTBB24

• Provides the clocking service necessary for digital networks.
• Required if using DTI cartridge(s) or ISDN-BRI Interface cartridge(s).
• One Services cartridge supports all clocking required, regardless of the number or mixture of DTI's and/or ISDN-BRI Interface cartridges.
• Uses Slot B of the core ICS, and cannot be used if a Copper Expansion Upgrade Cartridge is installed.
• Compatible with the Modular ICS core only.

Two-Port Fiber Expansion Cartridge NTBB02

• Connects 2 additional Fiber Trunk, Fiber Station, or Analog Station Modules to expand core capacity
• Compatible with the Modular ICS only

Combination Fiber 6-Port Service Cartridge NTBB25

• The Modular ICS Combination Fiber 6-Port Services Cartridge connects additional Fiber Trunk and/or Station Modules to expand the core capacity of a Modular ICS equipped with XL or XC software to a maximum of 12 expansion ports (272 total ports maximum configuration).
• This refurbished cartridge also contains the clocking service required to support T1 or ISDN-PRI on a DTI cartridge or an ISDN-BRI Cartridge.
• The Combination Fiber 6-Port Services Cartridge fits into slots B and C of the Modular ICS and works with XC software, and regular DR 1.1 and later software. Requires fiber connections.
• Compatible with the Modular ICS core only.

Nortel Cards - 6 Port Fiber Expansion Card NTBB06GA

• These Nortel cards connect up to six additional Fiber Trunk, Fiber Stations, or Analog Station Modules to expand core capacity
• XC software enables the installation of two Six-Port expansion Cartridges in the modular ICS
• Compatible only with the Modular ICS